Home Dodge Ford Marine Fuel hose Turbo Heat Shields Shipping

Stainless Steel Turbo heat shield   for 94 and later Dodge Cummins.

 
This Stainless Steel heat shield deflects turbo heat away from the aircleaner reducing air intake temp. It will not retain heat in turbo. Enhances engine looks too. Made of polished stainless steel. For mounting you will need to drill and tap three #8-32 holes in the non-critical flange area of the compressor housing. The required screws are included. This shield will work with any air filter. Stock, K&N, BHAF, Cannon, Scotty or anything else. 
 
 
 
$19.95 #HX35 TurboShield Fits HX35 turbo used on 94-2001
$19.95 #Hy35 TurboShield Fits Hy35 turbo used on some 2001 year models
$19.95 #HX40 TurboShield Fits HX40 turbo used on custom applications.
 
 
You can check which turbo you have by going to http://dodgeram.org/tech/dsl/FAQ/turbo_faq.htm
 
Money Back Satisfaction Guaranteed 

 

LarryB’s Stainless Steel  Turbo cover

Install instructions for Turbo heat shield for Dodge Cummins

PRIVATE "TYPE=PICT;ALT=turbocvr.jpg (29456 bytes)"PRIVATE "TYPE=PICT;ALT=tapping.jpg (14436 bytes)"

Do not remove plastic protective film from outside of shield until finished. This will protect against scratching the finish while installing.

1.    Remove air filter and box. You may avoid this step by using an angle drill.

2.    Place SS Shield on turbo. You may need to spread it a little to fit on compressor housing flange (front housing on turbo).

3.    Center the turbo oil feed line in opening on shield.

4.    Use holes in shield as guide to drill holes in compressor housing flange. Try to drill the holes approximately 3/8" from the rear edge of the compressor housing flange. Drill slowly to avoid breaking drill as you may break through flange and the drill may hit the steel snap-ring retainer. Use a #29 or a 9/64" drill.

5.    You can use either the #8 self tapping screws or use an 8-32 tap to tap the hole for the 8/32 screws. Use caution not to break tap by tapping too deep and hitting steel snap-ring retainer. See picture above.

6.    Install included screws, do not tighten yet Remove plastic protective coating and then tighten screws. Caution: Do not over tighten as the aluminum is soft and will strip easily.

7.    Reinstall air cleaner and parts.

8.    Your done now go show it off!

If you have any problems I'd like to hear about it. Please e-mail me at larrybuckinc(at)gmail.com with your comments. Thanks, Larry

 

LarryB's

Garrett T3 & T4 turbo stainless heat shield.

T3 shield small.jpg (10713 bytes)     turboheatshield small installed.jpg (64175 bytes)

Part#GT34   $74.95  

Polished Stainless shield, polished stainless brackets, stainless rivets. Also fits T3/4 Hybrid. This Polished Stainless Steel heat shield deflects turbo heat away from the air cleaner, lowering intake air temp. Also protects wiring and other sensitive areas. It will not retain heat in turbo. Made of polished stainless steel to enhance engine looks. Cover that rusty turbine housing and protect everything else under the hood too. This shield covers the turbine housing only to avoid interference with the many different downpipe configurations out there.

Dealer quantity discounts available, call Larry @ 253-272-1444

ts32.jpg (27902 bytes)